Brush-electrode pair M 25-300, #31003743

Gann brush-electrode pair M 25-300, #31003743

• Measurement up to 30 cm depth possible, the sample holes have to be pre-drilled with a 6 mm Ø drill.
• The electrodes can be used to create a moisture profile of the measured material by taking measurements layer by layer
• The electrodes are equipped with a practical screw-in and screw-out aid, with which they can be easily screwed in and out of the material to be measured.
• As the stainless steel brushes bond excellently with the material to be measured, no additional contact agent is required.
• The insulation on the shaft prevents unwanted influence of surface moisture on the measurement result
• The brush electrodes are made of resistant and stainless V2A steel.
• The electrodes should always be used in pairs and should ideally be inserted into the material to be measured at a distance of approx. 8 - 10 cm from each other.

• Hydromette BL E (00001)
• Hydromette BL E (11300)
• Hydromette HB 30 (1510)
• Hydromette HT 85 T (1370)
• Hydromette M 4050 (1400)
• Hydromette RTU 600 (1670)
• Hydromette UNI 2 (1550)